Hot Rods Desoto Hemi pushrods

Hi guys,
Would anyone happen to know the length of the pushrods in a Desoto low deck engine
I have looked several times and can’t seem to find any info .
This is the 291 Desoto low deck engine.
From what I have read,,,the intake and exhaust are different lengths as well,,,,correct?
My engine didn’t have any pushrods when I got it,,,,so I am lost .
At least with some numbers I can scout around and measure any I might find .
Thanks guys .

Tommy

 

If you don't find your answer here call Hot Heads. They are uber helpful and knowledgeable.

 

I may have a set I can look at and measure.I can check tomorrow. I have a 291 crated up and saving for retirement project I.... Been sitting a while so I can't remember all the components I have

 

Anybody,,,,,anybody ?

Tommy

 

Well,,,,after further investigation,,,,I think I might have the info I need .
If what I have found is correct,,,the pushrods are :

Intake are 8.8 long
Exhaust are 10.11 long

If anyone has more information,,,,please speak up.
I’m not getting them yet,,,,,but I try to investigate before hand to know the direction I want to go .

Tommy

 

Sorry I couldn't find any and was too busy to post. Good luck with your 291. Post a build thread if u can

 

Yeah I plan on it.
I’ve been working on this for some time,,,,,,it has been bored and machine work done .
It’s on the back burner right now,,,,,health reasons,,,,,,but I’m still getting things in order,,,,because I plan on getting back to it someday.
I have most of the stuff for the short block,,,,still need all the head work done .
Still in the planning stage too,,,,,I haven’t had the cam reground yet,,,,,still deciding on the profile I want .
It will come together in time,,,,,,and money,,,,,,LoL !

Tommy