Hot Rods driveline question

i am setting up my rearend and after i get my pinion angle set at 3 degrees up i am only going to have roughly 3/4" of difference in height from my trans tail shaft to the center of my pinion. is this going to be acceptable? everything is still just mocked up so i can still make changes easy enough i just would like to leave it where it is.
thanks for the help.
shockley.

 

Yes.

 

As long as the tailshaft and the pinion are on the same plane (parallel) it should be fine.

 

Thank you. Now I can move forward without stressing anymore. Well for now!

 

No stress. It's just a car.