Ford F1 front axle orientation

hi all, can anyone tell me if the 48-52 ford f1 axle has a front side or is it symmetrical? The factory shop manual says caster and camber are built into the axle. And the axle is already installed so it isn't easy to check the king pin angle on the axle. Any markings on the axle to indicate the front?

 

Welcome to the HAMB from Illinois.

 

sorry I havent been here in a long time. I think I put this in the introduction page. Trying to learn the structure here, not easy at my age. I cannot tell what is a post, a thread, or a conversation... nor the difference between a forum and message board.

 

I suggest you post your question over here:
https://www.jalopyjournal.com/forum/forums/the-hokey-ass-message-board.5/

 

I can try again...I thought that was were I was at the first time.