Hello from the middle of Montana!

Hello I am Sheldon and I am now in the possession of my Grandfathers 1937 Ford Fordor Humpback Sedan that he purchased new in April of 1937. This car is very rough and needs a lot of parts as well as tlc. I was going to pull the frame off however after reading an article I have determined that that was not a good idea until after some body work was done. That brings me to the first question. Where am I going to find a floor pan that is complete? I thought I had seen 1 after searching the web but unable to relocated it. I do currently have a donor car but that floor is worse than the original. I have seen kits, however I am a little uneasy about welding 7 pieces together to be an exact replica of the original. Any suggestions?

 

Welcome to the HAMB from Illinois.

If you don't get answers to your question, post it over here to get more views:
https://www.jalopyjournal.com/forum/forums/the-hokey-ass-message-board.5/

Here is one source:
https://www.hotrodssheetmetal.com/19foshme.html

And another:
https://directsheetmetal.com/collections/frontpage/ford-direct-sheetmetal-floorboard