Intro

A couple years have past from when I first joined. Have a hard time setting inside the house, but time and age has caught up with me and I cant take the cold wx outside. Once it gets above 70 degrees I want to be ready to get out there and warm up the old cars.
Anyway, lookin for suggestions on my old Dodge truck. It is a 58 D100 with a 56 Dodge 315 Poly (D63-3).I think this was is an original four barrel engine however, it has a stock two barrel on it. I would like to replace it with a modern four barrel -Edelbrock/Holly (500-600 cfm) with reliability the main idea.
I have a factory single four barrel intake from a 57- 325 Dodge Hemi and a stock wcfb. I would like to install the intake but would like to replace the orig wcfb with a new carb.
Any suggestions about adaptors or forget the whole idea, as it has ran good for the last fourty six yrs with the two barrel.
Thanks for any input.
Old58

 

This is the intro forum. Move questions to the main forum for answers. Good luck!

 

Welcome! not sure about the Poly but This would be a great place to ask, browse and post some photos> 48-60 Dodge truck Thread Welcome again and enjoy!