Register now to get rid of these ads!

introduction

Discussion in 'New to the H.A.M.B.? Introduce yourself here!' started by fishermantim, Nov 6, 2011.

  1. fishermantim
    Joined: Aug 3, 2011
    Posts: 13

    fishermantim
    Member
    from california

    51 block.jpg

    more 51 block.jpg

    51 heads chambers.jpg

    pistons, oil pump.jpg

    side shift trans.jpg

    pressure plate and clutch plate.jpg Hello, Fishermantim here. I've been on this forum since august 2011. This is my first attempt at posting. I have an early 50 f1 pickup and a 51 panel truck. I would like to have at least one of them driveable before I'm too old to enjoy them. I'm really lacking in knowledge and tools to get them in running condition. I've had them for years and have collected parts for both. My intentions were to hot rod the pickup and to have the panel stock. I know I was too premature at tearing down and dismantling parts. I should have waited until I had a concrete plan and budget. I have had fun dismantling the 51 v8 though. My boat and honey do projects have kept me busy during the summer. I still have the honey do project to finish. That is remodeling the old kitchen into a formal dining room. I'm past the plumbing , electrical, drywall and texturing and paint. Next is the floor covering and lighting. Then back to the flathead project.
     
    Last edited: Nov 6, 2011
  2. Old&Low
    Joined: Mar 13, 2010
    Posts: 410

    Old&Low
    Member

    Welcome from New Mexico!
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.