No Ordinary Table

Thought I would thow up a link to the video of the coffee table I built. Before anyone jumps on me for the god awful rollers I used I will admit they are not ***y and are in need of a swap. Bottom line though I built this for basically the cost of an $8 can of engine paint. I think it is pretty cool. I found an aluminum V6 behind a dealership here in town that said it was mine if I could lift it into my car. One week later I had a table that can hold a six pack like no other. Just thought I would post this and see if anyone has morphed any other automotive parts into other stuff. As a side note the entire project was built on my third floor apartment sun deck. The people living on the second floor probably hate me for this one.

http://www.youtube.com/watch?v=hrkrzVmjWO8

 

Actually, it is pretty cool. Right on.

 

very cool

 

pretty cool! i made an end table from a studebaker steering wheel

 

any pictures of that end table? sounds interesting.

 

Nice job, but it reminds me of the one that was all over the internet a little while back.



CBB

 

i have been planning to make one out of a flathead V8. Looks good though.

 

Someone please use a real windshield or other car gl***.

 

Nice Job Tyrell!...Sent you a PM....Jethro

 

very cool man!!