Hot Rods Repop sheet metal fit?

I have been looking for a good front fender for my '57 Chevy truck for a few months now and all I'm finding is junk. I went to a couple swap meets and no luck. I've decided to go ahead and buy a reproduction fender so I can get my truck back on the road and then keep my eye open for an original one down the road. Does anyone have any experience with any aftermarket sheet metal dealers? I was leaning towards AMD or Goodmark. Does anyone have any experience with these? Thank you

If you know of a front p***enger fender for a 1957 Chevy truck feel free to message me. Thanks

 

AMD is the Top of the Line in aftermarket sheetmetal.

I use them all the time.

VR&C.

 

×2 on that. I've used AMD stuff on off OT cars before and its very nice. The stuff LMC sells is pretty poor fitting from what friends have used.