Show your cool finned aluminum parts

just added a pair of big block Mickey Thompsons

 

I have two sets of these wheels. Pretty hard to find.

Posted using the Full Custom H.A.M.B. App!

 

216 chevy Edmunds

 

Here`s my Avanti engine with a few finned goodies.

 

just picked this stuff up the other day.
staggered Corvette Valve Covers and MT valve covers and a finned small block oil pan.

 

My NOS Filko coil.

 

For the y block guys


Posted using the Full Custom H.A.M.B. App!

 

I just stumbled onto this NOS Eelco SBC oil pan on e-Bay, $1.3K The seller also has a M/T SBC pan for the same price.

 

I have a set of Big block Chevrolet Cal Custom valve covers,

 

Brake cooling scoops.

 

I would like to own these

 

liking the steering wheel

 

Be careful with Aluminum oil pans with drain plug hanging down. My buddy pulled in to gas station and snagged the drain plug on the under ground tank manhole. Ripped the back out of the pan and dumped all the oil in front of the pump. Tow home.


Ago

 

O. K. Jim I'll play. Here's a couple of pieces I made with a table saw and a router for my roadster.

 

Offenhauser hood scoop!

 

How about some 09 valve covers.

 

Yea the drain plugs do hang pretty low. The thing thats really pissing me off is that the damn thing WILL NOT STOP LEAKING up front. All bolts are snug. Pan is flush against the block. The front rubber U gasket looks like its sealed off tight, but nope. Oil is still finding a way to seep out around it. I went over it with RTV too. Ive dropped the pan twice already.

 

Use a button head for the drain plug and clean the pan , block and timing cover real good and use Right Stuff its bad ass.

 

I have a set of Keystones on my Windsor


Posted using the Full Custom H.A.M.B. App!

 

They could be in your garage, send me a PM.

 

000E2084 by Jakesrocks posted Jul 21, 2014 at 2:36 PM

000_2086 by Jakesrocks posted Jul 21, 2014 at 10:33 AM

100E1504 by Jakesrocks posted Jul 21, 2014 at 3:43 PM

The Ludwig base drum pedal will soon be my throttle pedal.

 

Are those "Shine" bottles covering those carbs.

 

Not much to show here, just a Lucas coil holder. JW

 

I just scored a finned rocker cover for my Holden six, which I won't show due to engine being an 83 year. Been wanting one for some time.
I to have the finned sickness.
Just found a finned triple carb manifold for a 9 port head, but I need it to fit a 12 port. Hopefully a competent alloy welder can modify it for me.
Next biggy will be, do I paint between the fins, or not.

 

******************************************************************

I'm liking that dash panel. I have to ask though, did you cast that, or is it carved out of billet and dressed up to look cast? I'm thinking that may be the way to go in my T.

Roger