Smokey Yunick SBC Manifold

designed By Smokey Yunick, built by Edelbrock. not many made. this one looks like it has been set into a SBC valley but never bolted down. PO has probably used a Dremel like tool to etch a better seat at each end. intake top looks like it has never had a bolt in it. runners have been epoxied in at ends to help direct fuel flow. 2 homemade gaskets included. own a piece of history. $700 + shipping to the lower 48. thanks, mike roman (the junkyard pirate).

 

just a bump for "the best damn garage in town"

 

I will deliver FREE to Wheeling WV. meet at Cabela's Plaza

 

but only on the days Cheddars is having a meatloaf special.

 

I think thats on tuesday

 

meatloaf. mashed and corn. MMMMM, MMM Good

 

Smokey is rollin in his grave, pissed that no one cares

 

will it fit this engine?

 

Bob says YES

 

Bob's right, i tried it and it fits, might need a little grindin, but I can get it to work

 

had to grind a bit more than i wanted. it's now for a two-barrel

 

been entertaining the idea of a slight price reduction.

 

no Bob, thats too low

 

after eavesdropping on a bar conversion between two guys, both wearing Don Garlits T shirts, talking about some guy in Canonsburg Pa. that has a SUPER RARE Smokey manifold that just might be the only one left in the world, I have decided to RAISE the price.

 

tryin to decide if one MILLION is too much. some one help me out there. not you Bob, you're a cheap *******