Hot Rods Surfacing Cylinder Heads With Sandpaper and Granite Surface Block...

I was not even that young. Tried doing that on aluminum SBC heads, after screwing around on a flat gl*** plate for an hour, and not getting an even finish...took them to the local machine shop.

 

Adhesive back Porter Cable 80 in a roll is mighty handy. It sticks well to granite or gl***, and you can stick strips of it down very carefully with the edges flat and tight.

 

> <I tend not to over think this stuff these days> >

Yes. We can see that. Guess you ***ume gl*** won't bend mounted in its frame even if the rest of the table doesn't..