Tech: Cheap replacement T5 Shifter

X3

 

There are a couple shots on how I did mine here...http://www.jalopyjournal.com/forum/...ustom-51-gmc-shop-truck-project.872678/page-2

 

I plan on doing this too. There are tons of them on ebay that look identical. What is the spacing on the shifter handle screw holes? I think I'm going to use a Lokar handle if possible.

 

Hurst standard is 7/8", center-to-center.

 

It looks like the flat part on the shifter is on the wrong side but I can't imagine it'd be too hard to take it apart and rotate it 180°. This is the handle I'll be using.