Hot Rods THE INDUCTION THREAD

Webers on a small bock chevy 6tz road course racer style :

 

wow Mikey that’s one I haven’t seen and at first glance I thought I dig a blown sbc with a hilborn e type injector then I looked closer and realized it was a y block ford while they are neat engines and I’m sure Tim McMasters is gonna scold me but I bet that blower disintegrated that old ford in about one p*** lol

 

Depends on the tune…

 

And a similar intake down here in New Zealand, where they are rare as rocking horse poo. I bought it as few years back, stored it at a mates place 500 miles away, and havent yet got around to collecting it.

Am thinking it would be a great piece if I were to build a Dan woods type C Cab. I traveled to the USA last year for the GNRS and was fortunasate to be taken to the Galpin shed in LA

 

Yea Jackson, I agree. Pretty sure its a cackle car only.

 

Hey Man, that's the Schithead Bros 409 A Coupe engine!

 

my latest.

 

that’s what I’m talking about nothing like a blown Hemi with a enderle barn door injector I sure could use that idler bracket for my delta blower drive on my 394 olds but at least it’s being used well

 

I knew you would like that set up. It's a good shot of the barn door and pulleys

 

COOL! What is this thing....?

 

I think it's one of Micky Thompson Pontiac creations.

 

Yes, one of Mickey Thompson's creations, but I have never seen a colorized version that's pretty cool.

 

I’m surprised that WCFB’s were used for this dyno test rather than AFB’s. Can @carbking offer any thoughts?

 

Factory or home cast ?

 

My scanner died so I only have these photos to post, here’s an Offy BBC tunnel ram top half for a 6-71. The one you pictured looks very recent and it’s gusseted unlike the one I’m showing. The magazine pages I had in a binder aren’t dated, I’m thinking it was an early ‘70’s article. Also it looks like Ollie Morris that worked for Offenhauser machined the 2-4 top of a tunnel ram flat and bolted a 1/2” aluminum plate to it for the 6-71.



One more thing I just noticed, the pop off is labeled OFFY, Offenhauser speed equipment was barred by a judge from using that, all their stuff was Offenhauser. Someone else made those patterns and castings.

 

I’ve got a 440 that I’ve always thought it would be cool to put a tunnel ram with thermal quads. I think it would work great on the street and the track, I think the look would be different from the other carbs normally used.
I’ve only seen one photo of a big block Mopar with the setup so I know it worked for one crazy fool.

 

'posted this slow moving project elsewhere but,
not to this thread

 

Very nice on the olds,who did your drive system?

 

thanks, I bought the lower hub here on the HAMB from racer756 and pieced the rest together from various blower parts vendors, modifying parts as needed.

 

My new carbs, blower referenced holleys. Glen

 

Hot rod?

 

Very nice, 2 inch belt, remote thermostat housing, looks great!

 

Another question paul, where did you get that remote thermostat housing as I'm going to have to run one and that one looks nice