Customs Truck arm suspension swap with guidance and criticism

ALLDONE · Jan 23, 2025

here's a pic.... not the best, harbor freight/ home made welder

the blue line is the haze mark/ affected zone...with out it you have whats called by inspectors is lack of off fusion ...

ALLDONE · Jan 23, 2025

stinkity stoink said: ↑

Not offended one bit and I’m sure there are plenty of people that know a lot more than me.
I see a pretty consistent haze on the backside and see some penetration on the back in some areas. I think it’s good , but I can take the criticism.
I did a bunch of welding tests before I started to dial in setting. I wasn’t that concerned about looks just penetration. I did cut and etch test and they showed good penetration and BFH test. I was able to fold some pieces over flat from 90 without breaking. Some broke , but it was probably beyond 45 of bending.
Click to expand...

and to not confuse.... I know nothing about any thing, made it to 71.5 by the grace of god...i'm king of the non knowing about anything here...

Log in or Sign up

Customs Truck arm suspension swap with guidance and criticism

ALLDONE
Member

from VIVA LAS VEGAS

ALLDONE
Member

from VIVA LAS VEGAS

Share This Page

Archive

Atomic Industry

Support

Subscribe

Log in or Sign up

Customs Truck arm suspension swap with guidance and criticism

ALLDONE Member from VIVA LAS VEGAS

ALLDONE Member from VIVA LAS VEGAS

Share This Page

Useful Searches

Archive

Atomic Industry

Support

Subscribe

ALLDONE
Member

from VIVA LAS VEGAS

ALLDONE
Member

from VIVA LAS VEGAS