Register now to get rid of these ads!

Technical Welding table fixtures

Discussion in 'The Hokey Ass Message Board' started by tubman, Nov 10, 2025 at 4:29 PM.

  1. tubman
    Joined: May 16, 2007
    Posts: 8,172

    tubman
    ALLIANCE MEMBER

    I finally measured the width of the slots in my welding table today. They are a full 1 1/4" wide. Thinking about it tells me that the are that large to accommodate "C"-clamps, vise-grips and other miscellaneous tools rather than some specialized equipment.

    Thanks to all who participated.
     
  2. noboD
    Joined: Jan 29, 2004
    Posts: 8,962

    noboD
    Member

    It would be easy to make T nuts to fit there too.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.